The comfort remote control of your Dimplex heat pump

With the Dimplex SmartRoomHeating App your Dimplex heat pump is now online. With the SmartRoomHeatingApp have you from anywhere (Note system requirements) Access to your Dimplex heat pump directly via the iPhone^®, iPad^® and iPod^® touch.

In combination with the Smart RTC room temperature controller, the room temperature can now be set differently for up to 20 rooms via the app. The standard integrated heat pump manager intelligently and automatically ensures maximum efficient operation.

The most important functions at a glance:

• Fast and convenient monitoring of the heat pump status

• Change of mode and setpoint temperatures

• Increase and decrease times of heating curves


• Access to home ventilation units of the ZL ... V / ZL ... H / ZL ... H-C series

SRH App
Open
editor	Glen Dimplex Germany GmbH
Operating system IOS	from IOS 8.0
Version 2.6.6	23.10.2019
Android operating system	Not planned!
languages	German English French Polish

System requirement

The minimum system requirement for using the SmartRoomHeating App is an internet access¹, a Dimplex heat pump with heat pump manager WPM 2006, WPM 2007, WPM EconPlus or newer, as well as one NWPM extension for integration into the network, with at least Firmware A1.5.0. The SRH app requires iOS 8.0 or higher. The smartphone must have active internet access¹ to be able to access the heat pump.

¹When accessing the Internet, additional costs may arise depending on the DSL and mobile phone contract.

installation

The installation of the SRH App takes place via the AppStore with your smartphone or iTunes.

to register

Before you can start, the SRH App and the heat pump with the server. Registration is necessary so that both sides can speak to each other.

The following figure shows a schematic of the communication after the registration has been completed.

Open

Scheme of communication

Installation and registration video

An installation and registration video of the SRH App made available: Dimplex Wärmepumpe NWPM - Plugin updaten + mit der SRH App verbinden | Dimplex

Registration of the SRH app

To register the SRH App will

• a user name of your choice

• a freely selectable password

• the serial number of the heat pump

needed. The serial number (serial number) can be read off the type plate of the heat pump.

When registering the SRH App the fields serial number, password and user name must be filled out and the registration confirmed. The serial number is then checked. If the registration was successfully completed, the system ID and the system key are reported back. The system identifier and the system key are then required to register the heat pump. The comparison of the SRH App with the heat pump.

Registration of the heat pump

A NWPM extension with the Firmware A1.5.0 or newer and one Plug-in needed. If a plug-in is already installed, the status message "Ready" is output. If the status message "Ready" is not displayed, the plug-in has not yet been installed.

• The heat pump is registered via the menu «settings»-«Remote control" carried out

• Note the server address monitoring.gdts.one!

• "System ID" and "System key" access data from the registration of the SRH App in the interface and set the online access to "Yes" and save

• A short time later, the successful login is displayed in the status

link

If the above steps have been carried out successfully, the SRH App started and carried out the login using the specified access data. After a successful connection, the start screen of the SRH App displayed.

Error messages

Since not all software versions of the heat pumps have yet been released, a check is carried out first. If the test is successful, the SRH app starts in the home screen. If the test is unsuccessful, a message will be displayed.

Versions

Contact

For further questions, information and suggestions, please send an email to:

ferndiagnose@gdts.one

with the additional information of:

• Device designation

• Software version